Agilent Technologies ENA Series User Manual page 222

Rf network analyzers

Hide thumbs Also See for ENA Series:

Table of Contents

Power Calibration

Creating loss compensation table

Follow these steps to set the loss compensation table.

Step 1. Press

Step 2. Press

Step 3. Select a port (see "Selecting target port of error correction" on page 215).

Step 4. Press

Step 5. Set the frequency (

the following hardkeys and softkeys.

For a frequency other than one set in the table, a value obtained by linear interpolation of

the losses at the 2 points adjacent to the frequency is used. If a frequency is lower than the

lowest frequency in the table, the loss at the lowest frequency is used; if larger than the

highest frequency in the table, the loss at the highest frequency is used.

Clear Loss Table

When setting the table by using the front panel keys or the keyboard, you need to first set

focus on (select) the operation target (table or softkey). You can change the focus by

frame of the table is displayed as bright as the window frame of the active channel. When

the focus is placed on the softkey menu, the softkey menu title area is displayed in blue.

Power Calibration

) and the loss (

does not affect the current setting of the loss compensation table.

If you select a cell and then press this key, you enter the mode that

allows you to edit the cell character by character. If you change a

value and then press this key, the value is entered in the cell.

Moves up or down in the cell selected in the table. In the

character-by-character edit mode, you can select an item or perform

a stepped change of data.

Moves right or left in the cell selected in the table.

Enters a value in the cell.

Deletes the line in which the selected cell is included.

Adds a new line above the line in which the selected cell is included.

Resets the table.

in the ENTRY block. When the focus is placed on the table, the window

) of the loss compensation table by using

Troubleshooting

E5070b E5071b