NOTE
Step 1. Press the
Step 2. Press the
Setting the Measurement Frequencies
Three frequency modes are available:
•
— the measurement frequencies are obtained from the start
Sweep
and stop (or equivalent center and span) frequencies and the number
of measurement points.
•
— the measurement frequencies are obtained from the frequency
List
list entries.
•
— where the measurement frequency is taken at single fixed
Fixed
frequency.
Selecting Sweep Frequency Mode
You can press
Full Span
default full range setting. If you do this after a calibration and the
calibration has been made over a narrower frequency range, it
invalidates the calibration.
Frequency/Points
Freq Mode
.
Freq Mode(Sweep)
Chapter 2
Setting the Measurement Frequencies
at anytime to return the frequency range to the
key.
menu key and set the frequency mode to
Making Basic Measurements
29