Setting Control Line - Agilent Technologies ENA Series User Manual

Controlling E5091A
Setting E5091A
Figure 13-4 E5091A property
Operational procedure
Step 1. Press
Step 2. Press
is set with the bit switch on the rear panel of the E5091A. (Figure 13-3)
Step 3. Press
NOTE The enable (
channels.

Setting control line

The E5070A/E5071A can control the output from the control line (Figure 13-5) of the
E5091A and control the DUT (for example, switching the frequency band of the front end
module). The procedure is shown below. For the specifications of the DUT control line,
refer to E5091A Users & Service Guide.
Figure 13-5 Control line
274
-
E5091A Setup
and then select the ID whose E5091A property you want to display. The ID
Select ID
to enable it (
E5091A Property
)/disable ( ) setting of the E5091A property display is executed for all
ON OFF
to display the E5091A setup menu.
) to display the E5091 property.
ON
13