Controlling E5091A
Setting E5091A
Setting E5091A
This section describes the setting of the E5091A. Table 13-1 shows the flow of the setting.
Table 13-1
Setting flow for E5091A
Item
"Selecting ID for E5091A" on page 272
"Assigning test ports" on page 273
"Displaying the E5091A property" on
page 273
"Setting control line" on page 274
"Enabling control of E5091A" on
page 275
Selecting ID for E5091A
Set the set target ID to the ID of the connected E5091A.
Step 1. Press
Step 2. Press
the rear panel of the E5091A. (Figure 13-3)
NOTE
Change the ID bit switch setting when the E5070A/E5071A is turned off.
Figure 13-3
ID bit switch of E5091A
272
-
E5091A Setup
and then select the ID of the E5091A. The ID is set with the bit switch on
Select ID
Description
Select the ID of the E5091A you want to
set.
Assign between the test ports of the
E5070A/E5071A and those of the E5091A.
Display the E5091A property to check the
port setting.
Make the setting of the control line to
control the DUT.
Enables the functions of the E5091A.
to display the E5091A setup menu.
13