Renault Laguna III Manual page 2880

OPENING ELEMENT MANAGEMENT
Fuel filler flap locking motor: Removal - Refitting
Fuel filler flap locking / unlocking is controlled simulta-
neously with the driver's door.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Switch off the ignition.
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove the rear right-hand wheel arch liner (see
Rear wheel arch liner: Removal - Refitting) (55A,
Exterior protection).
B91
a Remove the rear right-hand wheel arch liner (see
Rear wheel arch trim: Removal - Refitting) (71A,
Body internal trim).
K91
a Remove the rear right-hand light access flap.
II - REMOVAL OPERATION FOR PART
CONCERNED
a Disconnect the motor connector (1) .
a Remove:
- the motor nut (2) (located at the side of the flap in
the wheel arch),
- the motor.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Refit the motor.
a Connect the connector.
II - FINAL OPERATION.
K91
a Refit the rear right-hand light access flap.
B91
a Refit the rear right-hand wheel arch liner (see Rear
wheel arch trim: Removal - Refitting) (71A, Body
internal trim).
a Refit the rear right-hand wheel arch liner (see Rear
125096
wheel arch liner: Removal - Refitting) (55A, Exte-
rior protection).
87C-9
87C
125097