Match Origin - Dell S4810 Reference Manual

match ip route-source
routers.
match route-type
match tag

match origin

To match routes based on the value found in the BGP path ORIGIN attribute, configure a filter.
S4810
Syntax
match origin {egp | igp | incomplete}
To disable matching filter, use the no match origin {igp | egp |
incomplete} command.
Parameters
egp
igp
incomplete
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
pre-Version
6.1.1.0
280
— redistributes routes that match routes advertised by other
— redistributes routes that match a route type.
— redistributes routes that match a specific tag.
Enter the keyword egp to match routes originating outside
the AS.
Enter the keyword igp to match routes originating within
the same AS.
Enter the keyword incomplete to match routes with
incomplete routing information.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the E-Series.
Access Control Lists (ACL)