Standard Ip Acl Commands - Dell Z9500 Command Reference Manual

Usage
show ip
Information
accounting
access-lists
Field
"Extended IP..."
"seq 5..."
"order 4"
Example
Dell#show ip accounting access-list
!
Standard Ingress IP access list test on TenGigabitEthernet 0/88
Total cam count 2
seq 5 permit 1.1.1.0/24 count (0 packets)
seq 10 deny 2.1.1.0/24 count (0 packets

Standard IP ACL Commands

When you create an ACL without any rule and then apply it to an interface, the ACL behavior reflects an
implicit permit.
The Z9500 supports both Ingress and Egress IP ACLs.
NOTE: Also refer to the
sections.
deny
Configure a filter that drops IP packets meeting the filter criteria.
Z9500
Syntax
deny {source mask | any | host ip-address} [count [byte] |
[dscp value] [order] [fragments] [log [interval minutes]
[threshold-in-msgs [count]] [monitor]
To remove this filter, you have two choices:
•
•
222
Description
Displays the name of the IP ACL.
Displays the filter. If the keywords count or byte were
configured in the filter, the number of packets or bytes the
filter processes is displayed at the end of the line.
Displays the QoS order of priority for the ACL entry.
Commands Common to all ACL Types
Use the no seq sequence-number command if you know the filter's
sequence number.
Use the no deny {source [mask] | any | host ip-address}
command.
and Common IP ACL Commands
Access Control Lists (ACL)