Generate A Default Route - Dell Force10 MXL Blade Configuration Manual

The
show ip protocols
This interface no longer sends and receives the same RIP versions as FTOS does globally.
Figure 25-5. show ip protocols Command Example
FTOS#show ip protocols
Routing Protocols is RIP
Sending updates every 30 seconds, next due in 11
Invalid after 180 seconds, hold down 180, flushed after 240
Output delay 8 milliseconds between packets
Automatic network summarization is in effect
Outgoing filter for all interfaces is
Incoming filter for all interfaces is
Default redistribution metric is
Default version control: receive version 2, send version 2
Tengigabitethernet 0/0
Routing for Networks:
Routing Information Sources:
Gateway
Distance: (default is 120)
FTOS#

Generate a Default Route

When the traffic's network is not explicitly listed in the routing table, traffic is forwarded to the default
route. Default routes are not enabled in RIP unless specified. To generate a default route into RIP, use the
default-information originate
updates from other routes are advertised if you configured the
To configure FTOS to generate a default route, use the following command in ROUTER RIP mode:
Command Syntax
default-information originate [always] [metric value]
[route-map route-map-name]
To confirm that the default route configuration is completed, use the
RIP mode.
442
| Routing Information Protocol (RIP)
command example
Interface Recv Send
2
10.0.0.0
Distance
command in ROUTER RIP mode. In FTOS, default routes received in RIP
Figure 25-5 confirms that both versions are sent out that interface.
1
1 2
Last Update
Command Mode
ROUTER RIP
RIPv2 configured
globally
Different RIP versions
configured for this
interface
default-information originate
Purpose
Specify the generation of a default route
in RIP. Configure the following
parameters:
• always : enter this keyword to always
generate a default route.
• range: 1 to 16.
value
•
route-map-name
configured route map.
command in ROUTER
show config
command.
: name of a