Reset Features; Resetting To Factory Defaults Using G-Key Reset; Resetting To Factory Defaults Using Shutdown Reset; Resetting Display Settings Using V-Key Reset - Dell Wyse ThinOS C10LE Administrator's Manual

Chapter 3
32

Reset Features

Reset features include:
•
•
•
•

Resetting to Factory Defaults Using G-Key Reset

High-privileged or Stand-alone users can reset the thin client to factory default settings
using the G-key reset feature.
To reset the thin client to factory default settings, restart the thin client and
continuously tap the G key during the restart process. G-key reset impacts all
configuration items, including, but not limited to, both network configuration and
connections defined in local NV-RAM.
TIP: G-key reset is disabled for Low-privileged and Non-privileged users in Lockdown
mode.

Resetting to Factory Defaults Using Shutdown Reset

A High-privileged or Stand-alone user can reset the thin client to factory default
settings from the Shutdown dialog box as follows:
1. Select either the Shutdown the system or Restart the system option.
2. Select the Reset the system setting to factory default check box.
3. Click OK.
Shutdown reset impacts all configuration items, including, but not limited to, both
network configuration and connections defined in local NV-RAM (Terminal name will
not change).
TIP: Shutdown reset is disabled for Low-privileged and Non-privileged users, regardless
of lockdown state.

Resetting Display Settings Using V-Key Reset

If the display settings are inappropriate for the particular monitor that is connected, it is
possible that the display will not function properly when the thin client restarts. To
correct this, power-on the thin client while continuously tapping the V key. This will
restart the thin client with a display resolution of 640 x 480 pixels and a 60 Hz refresh
rate.

Accessing Thin Client BIOS Settings

After starting your thin client you will see a Wyse logo for a short period of time. During
this period you can press and hold the Delete key to enter the BIOS to make your
modifications (enter Fireport as the password). For example, you can use the F7 key to
use Optimized Defaults (load optimal default values for all the items in the BIOS setup
utility). NOTE: This does not apply to the T10 client (no BIOS on ARM).
"Resetting to Factory Defaults Using G-Key Reset"
"Resetting to Factory Defaults Using Shutdown Reset"
"Resetting Display Settings Using V-Key Reset"
"Accessing Thin Client BIOS Settings"