Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 952

Complete Software Guide for Junos
Additional Information
Required Privilege
Level
List of Sample Output
Output Fields
848
®
OS for EX Series Ethernet Switches, Release 10.4
—(EX4200 switches only) (Optional) Display system connection activity
all-members
for all members of the Virtual Chassis configuration.
inet | inet6 —(Optional) Display IPv4 connections or IPv6 connections, respectively.
—(TX Matrix and TX Matrix Plus routers only) (Optional) On a TX Matrix router,
lcc number
display system connection activity for a specific T640 router that is connected to
the TX Matrix router. On a TX Matrix Plus router, display system connection activity
for a specific T1600 router that is connected to the TX Matrix Plus router. Replace
number with a value from
—(EX4200 switches only) (Optional) Display system connection activity for the
local
local Virtual Chassis member.
member member-id —(EX4200 switches only) (Optional) Display system connection
activity for the specified member of the Virtual Chassis configuration. Replace
with a value from 0 through 9.
member-id
scc —(TX Matrix routers only) (Optional) Display system connection activity for the
TX Matrix router (or switch-card chassis).
—(TX Matrix Plus routers only) (Optional) Display system connection activity for the
sfc
TX Matrix Plus router (or switch-fabric chassis).
show-routing-instances —(Optional) Display routing instances.
By default, when you issue the
Matrix Plus master Routing Engine, the command is broadcast to all the T640 (in a
routing matrix based on a TX Matrix router) master Routing Engines or T1600 (in a routing
matrix based on a TX Matrix Plus router) master Routing Engines connected to it. Likewise,
if you issue the same command on the TX Matrix or TX Matrix Plus backup Routing Engine,
the command is broadcast to all the T640 (in a routing matrix based on a TX Matrix
router) or T1600 (in a routing matrix based on the TX Matrix Plus router) backup Routing
Engines that are connected to it.
view
show system connections on page 849
show system connections extensive on page 850
show system connections lcc (TX Matrix Router) on page 850
show system connections show-routing-instances on page 851
show system connections (TX Matrix Plus Router) on page 851
show system connections sfc (TX Matrix Plus Router) on page 855
show system connections show-routing-instances (TX Matrix Plus Router) on page 857
Table 143 on page 849 describes the output fields for the
command. Output fields are listed in the approximate order in which they appear.
0 through 3 .
show system connections
Copyright © 2010, Juniper Networks, Inc.
command on a TX Matrix or TX
show system connections