Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 926

Complete Software Guide for Junos
show pfe route
Syntax
Syntax (EX Series
Switch)
Syntax (TX Matrix and
TX Matrix Plus Router)
Release Information
Description
Options
822
®
OS for EX Series Ethernet Switches, Release 10.4
show pfe route
<<inet6 | ip | iso> <prefix prefix> | <table <table-name> <index index> <prefix prefix>>>
<mpls>
<summary>
show pfe route
<<inet6 | ip> <prefix prefix> | <table <table-name> <index index> <prefix prefix>>>
<mpls>
<summary>
show pfe route
<fpc slot>
<<inet6 | ip | iso> <prefix prefix> | <table <table-name> <index index> <prefix prefix>>>
<lcc number>
<mpls>
<summary>
Command introduced before Junos OS Release 7.4.
Command introduced in Junos OS Release 9.0 for EX Series switches.
Display the routes in the Packet Forwarding Engine forwarding table. The Packet
Forwarding Engine forwards packets between input and output interfaces.
NOTE: The Routing Engine maintains a master copy of the forwarding table.
It copies the forwarding table to the Packet Forwarding Engine, which is the
part of the router or switch responsible for forwarding packets. To display
the routes in the Routing Engine forwarding table, use the
table command. For more information, see the Junos OS Routing
forwarding
Protocols and Policies Command Reference.
none —Display all Packet Forwarding Engine forwarding table information.
—(TX Matrix and TX Matrix Plus router only) (Optional) Show the next hops for
fpc slot
a Flexible PIC Concentrator (FPC) slot.
On a TX Matrix router, if you specify the number of a T640 router by using the
number option (the recommended method), replace
7 . Otherwise, replace slot
if you specify the number of a T1600 router by using the
recommended method), replace
replace slot with a value from
have the same result:
user@host> show pfe route fpc 1 lcc 1
user@host> show pfe route fpc 9
—(Optional) Display Packet Forwarding Engine IPv6 routes.
inet6
with a value from 0 through
with a value from
slot
0 through 31 . For example, the following commands
Copyright © 2010, Juniper Networks, Inc.
show route
lcc
with a value from through
slot 0
31 . On a TX Matrix Plus router,
number option (the
lcc
through . Otherwise,
0 7