Table 141: Show Pfe Statistics Ip6 Output Fields - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Table 141: show pfe statistics ip6 Output Fields

Field Name Field Description
ICMP6 statistics, including the following:
ICMP6 Statistics
ICMP6 errors ICMP6 errors, including the following:
ICMP6 discard statistics, including the following:
ICMP6 Discards
show pfe statistics ip6 show pfe statistics ip6
icmp icmp
Copyright © 2010, Juniper Networks, Inc.
—Number of ICMP notifications sent to the PFE. If a throttler is configured, the number of
requests
notifications might not reflect all requests made. (See the
—When route lookups fail, ICMP packets are sent to the source. These packets
network unreachables
are ICMP Type= Destination Unreachable (3) and ICMP Code= Network Unreachable (0).
ttl expired —Number of notifications processed as a result of time-to-live (TTL) expiration packets.
ttl captured —Number of TTL expired packets sent by PFE interfaces to the Routing Engine.
—Number of ICMP errors sent with Type=Redirect (5).
redirects
—Number of ICMP errors sent with Type=Source Quench (4).
mtu exceeded
—Number of packets that the PFE hardware requests the PFE software to
icmp/option handoffs
process.
unknown unreachables —Unknown code (greater than 16) found for an unknown unreachable type
ICMP error.
—Any ICMP type other than UNREACH, REDIRECT, TIME_EXCEED, and
unsupported ICMP type
PARAM_PROB.
—When trying to find the neighbor to send redirects to, the PFE could not find
unprocessed redirects
the next-hop information.
—Any ICMP type other than UNREACH, REDIRECT, TIME_EXCEED, and
invalid ICMP type
PARAM_PROB.
—An incorrect protocol was detected by the ICMP processor.
invalid protocol
—The PFE software cannot map the interface index supplied by the chips to
bad input interface if1
a proper data structure in the microkernel.
—Number of requests dropped because of rate limiting by the PFE.
throttled icmps
—Number of packets for which the IP header length is less than the minimum length that is
runts
supported.
—ICMP packets are not sent for link-layer multicast packets. These are counted as invalid
multicasts
source addresses (not a unicast address or all zeros).
—ICMP packets were received from an invalid source address (not a unicast
bad source addresses
address or all zeros).
—ICMP packets were sent to an invalid destination address (not a unicast address
bad dest addresses
or all zeros).
—ICMP responses are sent only for the first fragments. The rest do not receive a
IP fragments
response. This is the count for ICMP requests that receive no response.
—Number of ICMP error packets.
ICMP errors
user@host> show pfe statistics ip6 icmp
ICMP6 Statistics:
0 requests
0 network unreachables
0 ttl expired
0 ttl captured
0 redirects
0 mtu exceeded
Chapter 36: Operational Commands for System Monitoring
throttled icmps
field description.)
831