Using RADIUS to Manage Subscribers Logging In to ICR Partitions
To configure RADIUS to manage subscribers logging in to ICR partitions on the router,
perform the following tasks:
Related Topics
Monitoring the Configuration of an ICR Partition Attached to an Interface
Display information about the ICR partition configured on an interface.
Purpose
Action
host1#show icr-partition fastEthernet 3/5/0.1 1
ICR Scaling Considerations on page 131
Configure inclusion of the ICR-Partition-ID VSA in RADIUS messages.
host1(config)#radius-include icr-partition-id acct-start enable
Issuing this command includes the ICR-Partition-ID VSA in Acct-Start messages.
To include the ICR-Partition-ID VSA in other accounting and access messages,
see the Configuring RADIUS Attributes chapter in the JUNOSe Broadband Access
Configuration Guide.
Enable or disable sending of the ICR Partition-Accounting-On or
Partition-Accounting-Off messages to the RADIUS servers.
host1(config)#radius icr-partition-accounting enable
For more information on enabling or disabling sending of partition accounting
messages to RADIUS servers configured on a virtual router, see the Configuring
RADIUS Attributes chapter in the JUNOSe Broadband Access Configuration Guide.
radius include
radius icr-partition-accounting
show radius icr-partition-accounting
Interaction with RADIUS for ICR on page 132
Configuring an ICR Partition on page 134
ICR Partition ID: part1A
ICR Partition State: Master
ICR Partition Grouping Criterion: SVLAN
SVLAN
VLAN
control-interface
-----------------------------------------------------------------------
100
Any
enabled
101
Any
enabled
102
Any
enabled
103
Any
enabled
104
Any
enabled
105
Any
enabled
Using RADIUS to Manage Subscribers Logging In to ICR Partitions
Chapter 6: Managing Interchassis Redundancy
vrrp-mac
advertise-mac
disabled
enabled
disabled
disabled
disabled
disabled
disabled
disabled
disabled
disabled
disabled
disabled
141
Need help?
Do you have a question about the SERVICE AVAILABILITY - CONFIGURATION GUIDE V 11.1.X and is the answer not in the manual?