System Debugging Commands; Display Diagnostic-Information - 3Com 5500-EI PWR Reference Manual

Bootrom Version is 3.03
[Subslot 0] 48 FE + 4 GE Hardware Version is 00.00.00

System Debugging Commands

debugging
Syntax
debugging module-name [ debugging-option ]
undo debugging { all | module-name [ debugging-option ] }
View
User view
Parameters
module-name: Module name.
debugging-option: Debugging option.
all: Specifies to disable all debugging.
Description
Use the debugging command to enable system debugging.
Use the undo debugging command to disable system debugging.
By default, all debugging is disabled.
Note that:
Enabled debugging will generate a great deal of debugging information and thus will affect the
efficiency of the system. Therefore, it is recommended not to enable debugging for multiple
functions at the same time. To disable all debugging at a time, you can use the undo debugging
all command.
The specific debugging information can be displayed on a terminal only after you have configured
the debugging, terminal debugging, and terminal monitor commands.
To display the enabled debugging types, use the display debugging command.
For information about the terminal monitor command, refer to Information Center Command.
Examples
# Enable packet debugging of the IP module.
<Sysname> debugging ip packet
<Sysname> display debugging
IP packet debugging is on

display diagnostic-information

Syntax
display diagnostic-information
1-8