Making A Multi-Mainframe Recording - HBM GEN Series User Manual

3.2.3

Making a multi-mainframe recording

1 Wait for the "MASTER SLAVE" status to display Synchronized before proceeding to the
next step.
Figure 3-5: MASTER SLAVE Synchronized
2 Press Run in the acquisition control panel to start a recording.
3 The signal on the master mainframe will now generate a trigger event. This trigger event
will be relayed to the slave mainframe.
4 The recording will now show the rising edge of the TTL level 1 Hertz signal recorded by the
master mainframe and the slave mainframe.
5 The recordings in both mainframes are started at the same time.
6 All recorded signals will match in time to within ± 50 ns.
If all signals match in time, the recordings were completed successfully.
34 I2710-1.0 en