Convectron Gauge And Foreline Adapter With Hose - Thermo Scientific ISQ 7000 Hardware Manual

4
Upgrade Equipment

Convectron Gauge and Foreline Adapter with Hose

Convectron Gauge and Foreline Adapter with Hose
394 ISQ 7000 Hardware Manual
A convectron gauge measures and controls the pressure in the foreline that is connected to the
turbomolecular pump and rough pump. If the foreline pressure gets too high, the convectron
gauge decreases the power going to the turbomolecular pump. The convectron gauge and
foreline adapter are connected to the foreline hose, which is connected to the turbomolecular
pump.
 To replace a convectron gauge and foreline adapter with hose
1. Shut down your system by following the steps in
page 109.
2. Use a T20 Torxhead screwdriver to remove the screw at each outside corner of the right
side panel.
Figure 454. Removing the Right Side Panel
3. Disconnect the vacuum hose from the adapter on the foreline pump.
4. Remove the rough pump clamp on the turbo pump and the adapter.
"Shutting Down the ISQ System"
Right Side Panel Screws
on
Thermo Scientific