Table of Contents
Advertisement
Thermo Scientific
10. Attach the 14-pin cable to the distribution board and ion gauge board.
Figure 453. Connecting the Ion Gauge Cable to the Distribution Board
11. Replace the right side panel and attach the screws holding it in place.
12. Slide the instrument closer to the GC.
13. Reattach the top cover panel and tighten the screw holding the top cover panel in place.
14. Restart your system by following the instructions in
4
Upgrade Equipment
Ion Gauge
Cable
Connector
"Restarting the System"
on
ISQ 7000 Hardware Manual
Ion Gauge
page
123.
393
Hide quick links:
Advertisement
Table of Contents
