Table of Contents
Advertisement
Thermo Scientific
7. Look through the left side of the instrument and use a T20 Torxhead screwdriver to
loosen the screw holding the board to the chassis. Loosening the screw will separate the
board from the instrument. The screw is captured, so do not attempt to completely
remove the screw from the board and bracket.
Tip The bracket has a white diagram describing the location of this screw. It is
approximately one inch from the top of the board directly under the white label.
Figure 354. Removing the Lens Driver Board
8. Lift the lens driver board out of the instrument. Be careful as space is limited.
9. Disconnect the Ethernet cable from the chassis and PC communication board.
3
Advanced Maintenance
Replacing the Boards in the ISQ 7000 Mass Spectrometer
Lens Driver Board Screw
ISQ 7000 Hardware Manual
325
Hide quick links:
Advertisement
Table of Contents
