Thermo Scientific
20. Reinstall the dynode/multiplier power supply by aligning its connector with the
connector on the distribution board beneath it. It will drop into the slot when it is in the
right position.
Figure 379. Reinstalling the Dynode/Multiplier Power Supply
Connector
21. Push the board down into the connector.
22. Reattach the three screws holding the dynode and multiplier power supply in place.
Figure 380. Reinstalling the Dynode/Multiplier Power Supply
Back
Screws
Dynode/Multiplier
Power Supply
Bottom
Screw
3
Advanced Maintenance
Replacing the Boards in the ISQ 7000 Mass Spectrometer
ISQ 7000 Hardware Manual
341