Thermo Scientific ISQ 7000 Hardware Manual page 322

3
Advanced Maintenance
Replacing the Boards in the ISQ 7000 Mass Spectrometer
294 ISQ 7000 Hardware Manual
7. Use a nut driver to remove the two 4.5 mm standoffs on the rod driver board.
Figure 310. Disconnecting the Rod Driver Board from the RF Board
Screws
8. Pry the 40-pin connector on the rod driver board away from the RF board.
Figure 311. Disconnecting the Rod Driver Board 40-Pin Connector
Standoffs
Rod Driver Board
40-Pin Connector
Thermo Scientific