Thermo Scientific
3. Open the manifold door and replace the front door alignment pins, magnet yoke, source
insertion guide, source magnets, or front manifold door o-ring as needed on the back of
the door,
Figure 264. Replacing the Source Retainer Magnets, Bracket, and Front Manifold O-ring
Source Retainer
Magnets
Front Manifold
O-ring
Magnet
Yoke
4. Close the manifold door and reattach the four screws.
Figure 265. Closing the Manifold Door
5. Restart your system by following the instructions in
3
Replacing Components of the Manifold
Screws
"Restarting the System"
ISQ 7000 Hardware Manual
Advanced Maintenance
Source
Magnets
Source
Insertion
Guide
on
page
165.
253