Table of Contents
Advertisement
Thermo Scientific
6. Set the analyzer tray on a clean, lint-free surface.
7. Hold the new source interface board next to the old board.
8. As you remove each of the wires from the old board, connect them to the same connectors
on the new board.
Figure 370. Reconnecting the Source Interface Board Wires
Source Interface
Board Wires
9. Follow the instructions in
analyzer tray.
10. Restart your system by following the instructions in
Replacing the Boards in the ISQ 7000 Mass Spectrometer
"Replacing the Analyzer Tray"
3
Advanced Maintenance
on
page 162
to reinstall the
"Restarting the System"
on
ISQ 7000 Hardware Manual
page
165.
335
Hide quick links:
Advertisement
Table of Contents
