STMicroelectronics STM32WLEx Reference Manual page 472

Analog-to-digital converter (ADC)
Bit 16 DISCEN: Discontinuous mode
This bit is set and cleared by software to enable/disable discontinuous mode.
0: Discontinuous mode disabled
1: Discontinuous mode enabled
Note: It is not possible to have both discontinuous mode and continuous mode enabled: it is
Bit 15 AUTOFF: Auto-off mode
This bit is set and cleared by software to enable/disable auto-off mode.
0: Auto-off mode disabled
1: Auto-off mode enabled
Note: The software is allowed to write this bit only when ADEN bit is cleared.
Bit 14 WAIT: Wait conversion mode
This bit is set and cleared by software to enable/disable wait conversion mode.
0: Wait conversion mode off
1: Wait conversion mode on
Note: The software is allowed to write this bit only when ADEN bit is cleared.
Bit 13 CONT: Single / continuous conversion mode
This bit is set and cleared by software. If it is set, conversion takes place continuously until it
is cleared.
0: Single conversion mode
1: Continuous conversion mode
Note: It is not possible to have both discontinuous mode and continuous mode enabled: it is
Bit 12 OVRMOD: Overrun management mode
This bit is set and cleared by software and configure the way data overruns are managed.
0: ADC_DR register is preserved with the old data when an overrun is detected.
1: ADC_DR register is overwritten with the last conversion result when an overrun is
detected.
Note: The software is allowed to write this bit only when ADEN bit is cleared.
Bits 11:10 EXTEN[1:0]: External trigger enable and polarity selection
These bits are set and cleared by software to select the external trigger polarity and enable
the trigger.
00: Hardware trigger detection disabled (conversions can be started by software)
01: Hardware trigger detection on the rising edge
10: Hardware trigger detection on the falling edge
11: Hardware trigger detection on both the rising and falling edges
Note: The software is allowed to write this bit only when ADEN bit is cleared.
Bit 9 Reserved, must be kept at reset value.
472/1306
forbidden to set both bits DISCEN = 1 and CONT = 1.
The software is allowed to write this bit only when ADEN bit is cleared.
forbidden to set both bits DISCEN = 1 and CONT = 1.
The software is allowed to write this bit only when ADEN bit is cleared.
RM0461 Rev 5
RM0461
.
.