Qinq Configuration Commands; Nest (Available Only On The Hpe 3100 V2 Ei); Qinq Enable - HP 3100 v2 Series Command Reference Manual

QinQ configuration commands

•
Throughout this document, customer network VLANs (CVLANs), also called inner VLANs, refer
to the VLANs that a customer uses on the private network; and service provider network VLANs
(SVLANs), also called outer VLANs, refer to the VLANs that a service provider uses to carry
VLAN tagged traffic for customers.
•
Selective QinQ is achieved through QoS policies. For more information about QoS policy
configuration commands, see ACL and QoS Command Reference.

nest (available only on the HPE 3100 v2 EI)

Syntax
nest top-most vlan-id vlan-id
undo nest top-most
View
Traffic behavior view
Default level
2: System level
Parameters
top-most: Inserts an outer VLAN tag in VLAN tagged traffic.
vlan-id vlan-id: Specifies a VLAN tag ID, ranging from 1 to 4094.
Description
Use nest to add a VLAN nest action to a traffic behavior. If the traffic behavior already contains a
VLAN nest action, the new one overwrites the old one.
Use undo nest to remove the action.
If a QoS policy contains a VLAN nest action, apply it only to the incoming traffic of a port.
Examples
# Create traffic behavior b1, and add the action of inserting outer VLAN tag 123.
<Sysname> system-view
[Sysname] traffic behavior b1
[Sysname-behavior-b1] nest top-most vlan-id 123

qinq enable

Syntax
qinq enable
undo qinq enable
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view, port group view
Default level
2: System level
181