Qinq Enable; Qinq Ethernet-Type Customer-Tag - HP 6125G Command Reference Manual

qinq enable

Syntax
qinq enable
undo qinq enable
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
None
Description
Use qinq enable to enable basic QinQ on the Ethernet ports.
Use undo qinq enable to disable basic QinQ on the Ethernet ports.
By default, basic QinQ is disabled on Ethernet ports.
A basic QinQ-enabled port tags received frames with its PVID tag.
Configured in Layer 2 Ethernet interface view, the command takes effect on the port only. Configured in
Layer 2 aggregate interface view, the command takes effect on the Layer 2 aggregate interface and all
the member ports in the aggregation group.
Examples
# Enable basic QinQ on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qinq enable

qinq ethernet-type customer-tag

Syntax
qinq ethernet-type customer-tag hex-value
undo qinq ethernet-type customer-tag
View
System view
Default level
2: System level
Parameters
hex-value: Hexadecimal Tag Protocol Identifier (TPID) value, ranging from 0x0001 to 0xFFFF. However,
do not set it to any of the protocol type values listed in Table 46.
195