Uploading Software - Inter-Tel AXXESS Manual

Installation
® ®
INTER-TEL AXXESS

12. UPLOADING SOFTWARE

12.1 The Board Utility program, supplied with the software can be used for loading software
on the CPC, CPU, T1/E1/PRI cards, BRS/BRU cards, and IP devices.
A. RS232 CONNECTIONS
1.
2.
OPTIONAL DB9M-to-DB25F
Programming PC
Page 3-170
MANUAL VERSION 11.0 – May 2008
Ensure that the programming PC is equipped with the DB Programming software. (See
page 6-17 in PROGRAMMING for details.)
Make the RS232 connection between the circuit card and the programming PC, as fol-
lows. The necessary connectors can be purchased separately or in the Universal RS232
Kit (part number 828.1282).
For CPC, CPU, and T1/E1/PRI cards:
Attach one end of an 8-wire reversing mod-to-mod line cord to the circuit card.
a.
CPC or CPU: Use the top RS232 port (labeled CPU SERIAL PORT 1) on
the CPC or CPU card. See
the serial ports.
T1/E1/PRI: Use the T1/E1/PRI serial port jack.
Attach the other end of the line cord to a DB9F-to-8P/8C modular adapter with the
b.
proper flow control. (This application does not require flow control unless the bps
rate exceeds 9600.)
If the PC does not have an available DB9M COM port but does have an available
c.
DB25M COM port, attach the DB9M-to-DB25F converter to the DB9F end of the
modular adapter.
Connect the cable to the appropriate COM port on the programming PC.
d.
ADAPTER 804.2574
DB9F-to-8P/8C MODULAR ADAPTER
Use either 804.2545 With Hardware Flow Control
or 804.2420 Without Hardware Flow Control
For IPC/IPRC/IPRC-Ds:
Connect one end of the Ethernet/10Base-T/LAN cable to the RJ45 connector
a.
labeled "LAN" on the card.
Connect the other end of the cable to the RJ45 connector on the LAN or network
b.
hub.
Figure 3-50 on page 3-107
EIGHT-WIRE, REVERSING
(INVERTING), MOD-TO-MOD
LINE CORD 813.1682
for a drawing showing
System
CPC/CPU or
T1/E1/PRI CARD
Uploading Software