Figure 3-86 Executive Or Standard Display Pcdpm Installation - Inter-Tel AXXESS Manual

Installation
® ®
INTER-TEL AXXESS
Figure 3-86. Executive or Standard Display PCDPM Installation
INSIDE OF BASEPLATE
J1
J2
P1
RS232
CONNECTOR
TO DSS/BLF UNIT OR
PC/OUTPUT DEVICE
NOTE:
Older PCDPMs (part no. 550.3014) require AC transformers when they are connected to DSS/BLF
Units only or PC/output devices only. PCDPMs do not require AC transformers when they are used for off-
hook voice announce only or have attached MDPMs. For a diagram of AC transformer requirements, see
Figure 2-7 on page 2-78. Also, Some early PCDPM-to-MDPM cables may have the stripe on the wrong
edge. If the MDPM doesn't respond properly, try reversing the connector on the PCDPM.
Page 3-196
MANUAL VERSION 11.0 – May 2008
PCDPM
MDPM
CONNECTOR
TO MODEM DATA
PORT MODULE
BACK OF DIGITAL PHONE
TO CHASSIS
J3
IF THE PHONE IS WALL MOUNTED, OPEN
THE BACK OF THE PHONE AND REROUTE
THE MODULE-TO-KEYSET
CABLE THROUGH THIS KNOCKOUT OVER
TO CONNECTOR J3 ON THE PHONE CON-
TROL BOARD.
Executive or Standard Display PCDPM Installation
TO
HANDSET
INTERFACE