Inter-Tel AXXESS Manual page 365

NOTE:
designed to hold the handset and line cords. For best results when connecting a hand-
set, uncoil a portion of the handset cord and push the cord into the channel so that the
flat side of the cord is against the phone.
Plug one end of the line cord into the wall-mounted modular jack (line jack unit) assem-
4.
bly. Plug the other end into the line cord jack on the bottom of the phone.
NOTE:
cuit number, extension number, and assigned user name for several seconds when
power is turned ON and the line cord is first plugged in. This display also appears after
a system reset, and whenever the line cord is removed and replaced while power is
ON. The station identification displays for several seconds, then the phone changes to
the appropriate display, depending on its current status.
If installing an Executive Display, Professional Display, Standard Display, Associate
5.
Display, Axxess Basic Digital, or Eclipse Basic Digital Phone, perform the digital
phone self-test as follows:
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
Digital Phone Installation
®
INTER-TEL AXXESS
The bottom of the Model 8500, 8520, and 8560 Phones have molded channels
To aid in installation and troubleshooting, display phones show their station cir-
While pressing the asterisk (*) and pound [hash in Europe] (#) buttons, unplug
and replace the phone line cord.
Release the buttons. The phone rings momentarily. (Display phones show a dark
display – all pixels lit.)
Lift and replace the handset. The phone rings momentarily. (Display phones show
a blank display – no pixels lit.)
Lift and replace the handset. The phone rings momentarily and all LED-equipped
buttons light. (Display phones show DKTS SELF TEST LED MATRIX.) If any of
the LEDs do not light, return the phone for repair.
Lift and replace the handset. The phone rings momentarily and all of the LEDs go
out. (Display phones show DKTS SELF TEST KEY MATRIX 00.)
One at a time, press each of the buttons on the phone in any order. If the button is
functioning properly, a key tone (or a DTMF tone for Executive and Professional
keypad buttons) is heard and, on display phones, a specific code is shown. (The
proper code for each button is diagrammed in
signal is not heard or the displayed code is incorrect, the button is faulty; return
the phone for repair.
Lift and replace the handset. The speaker tones are broadcast over the speaker-
phone speaker. (Display phones show DKTS SELF TEST SPEAKER TONES.)
Lift and replace the handset. Tones of various volume levels, from softest to loud-
est, are broadcast over the speakerphone speaker. (Display phones show DKTS
SELF TEST SPEAKER VOLUME.)
Lift the handset, then press and release the hookswitch. The handset tones are
broadcast over the handset receiver. (Display phones show DKTS SELF TEST
HANDSET TONES.)
Place the handset back in its cradle. The phone rings momentarily and it takes
approximately five seconds for the phone to return to normal operation. (Display
phones show DKTS SELF TEST COMPLETED! for several seconds. Then, as
described in the NOTE to step 4, the phone's identification displays for several
seconds.)
®
MANUAL VERSION 11.0 – May 2008
Figure 3-84 on page
Installation
3
3-185.) If the
Page 3-179