Inter-Tel AXXESS Manual page 410

Installation
® ®
INTER-TEL AXXESS
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
21.
22.
Page 3-224
MANUAL VERSION 11.0 – May 2008
NOTE:
If necessary, you can select CANCEL from any setup window to exit without
performing the installation. Also, during the file installation process, pressing ESC exits
the setup program without completing the installation.
A Welcome screen appears. Select
been installed before, you are asked to stop the Avdap service.
For a new installation, a Select Destination Directory window asks you for the desired
destination directory name. If the software has been installed before, the previous direc-
tory is the default value (default is C:\AVDAP or D:\AVDAP, depending on the factory
configuration of your Voice Processing PC). To use the default drive and directory
name, select . To select another drive and/or directory, select
Next
the displayed instructions.
If you are re-installing software, you are allowed to select which components you want
to re-install.
The Ready To Install screen appears. Select
A Voice Board Driver screen appears. Select
A Board Information window appears. You need to know what voice boards are
installed in your Voice Processing PC.
To add a board, select
a.
model depends on number of ports. For example, use RDSP/4000 for four ports,
RDSP/8000 for eight ports, RDSP/24000 for 24 ports, etc.
Set the Address to
b. 300
ond board and for the third board.
310
To change the Address, highlight the board and select
c.
To remove a board, highlight it and select
d.
Select to continue.
Next
An Interrupt Request (IRQ) window appears. Make sure the IRQ Value is set to
(default). Then select
Next
A Shared Memory Address window appears. Make sure the shared memory address is
set to (default). Then select
0xD0000
An Advanced Options window appears. Select
settings, make sure is selected. Then select
No
In the next screen, select
Finish
Another screen asks how many FAX ports the system has. Select the correct number
and then .
OK
A window appears stating that Voice Processing software has been successfully
installed. Select to continue.
Finish
A window appears informing you that you must restart the system to complete the
installation. Select .
OK
To install the Japanese voice prompts (if desired), remove the Applications Software
Disk and insert the Japanese Prompts Disk 1 of 3. Select
a:pmtsetup and press
the monitor.
NOTE:
If Japanese language prompts are not installed, yet a user attempts to access
them, English prompts are delivered instead.
to begin the installation. If the software has
Next
to continue.
Next
to continue.
Next
. Then choose the appropriate model from the list. The
Add
(default) for the first board in the PC. Use
Remove
to continue.
to continue.
Next
Advanced Options
Next
to continue.
. Then follow the installation instructions displayed on
ENTER
Voice Processing Software Installation
and follow
Browse
for the sec-
308
.
Edit
.
. In the Save Driver
to continue.
and then
Start Run
5
. Enter