Inter-Tel AXXESS Manual page 305

I. LOOP/GROUND START OR LOOP START CARD (LGC/LSC, LGC-D/LSC-D)
With a European system, new Loop Start Cards (LSC – part no. 552.2340) and LSC Daugh-
ter Cards (LSC-D – part no. 552.2341) have been modified to meet a regulatory compliance
requirement for EU Telco Directive 99/05/EEC. However, these new cards cannot be paired
with older LSC/LSC-D cards due to mechanical interference with some of the components
between the new and old cards. More specifically, new LSC-D revision level cards (artwork
version 826.5422-5) only work with new LSC revision level cards (artwork version 826.5421-
5), they cannot be used with earlier artwork version LSCs. Additionally, new LSC revision
level cards (artwork version 826.5421-5) only work with new LSC-D revision level cards (art-
work version 826.5422-5); they cannot be used with earlier artwork version LSC-Ds.
10.30 Install each LGC, LGC Daughter Card (LGC-D), LSC, and LSC Daughter Card (LSC-
D) as described below. See
trations.
NOTE:
power must be turned OFF to prevent damage to the card. All other cards can be inserted or
removed with power on.
Check to see that all components on the card are seated securely in their sockets and
1.
that no pins are bent.
Check the LSC fuses (LGCs do not have fuses). There are four specially-designed fuses
2.
on each card that cannot be replaced in the field (see
If installing a Daughter card, attach the LGC-D or LSC-D as shown in
3.
page 3-124
are properly aligned and seated.
NOTE:
sides of the cards facing each other. Also, LGC-Ds cannot be installed on LSCs, and
LSC-Ds cannot be installed on LGCs.
Install the LGCs and LSCs one at a time in the slots to be used for trunk connections.
4.
The component sides of the LGC/LSCs must face right. Any type of card may be
installed in any of the first seven slots (in any chassis), and slots may be skipped, if
desired.
NOTE:
default configuration, adjustments must be made in DB Programming. If changing card
types (e.g., changing from an LGC to a DKSC), see the programming procedures on
page 6-114
Loop/Ground Start or Loop Start Card (LGC/LSC, LGC-D/LSC-D)
INTER-TEL
Figure 3-59
When inserting or removing the CPC, CPU card, or Network Clock Card, the system
and Figure 3-60 on
Unlike the CPU combinations, these cards are attached with the component
If, when first powered up, the actual cards installed do not exactly match the
and to the information on
® ®
AXXESS MANUAL VERSION 11.0 – May 2008
CAUTION
on page 3-124 and Figure 3-60
page 2-47
page 3-125. Make sure the connectors and the standoffs
pages 3-16 and 3-17.
Installation
on page 3-125 for illus-
for more information).
Figure 3-59 on
Page 3-119
3