Table of Contents
Advertisement
Selecting sensor calibration tables
After you have edited a sensor calibration table, you can select it using the
following command:
[SENSe[1]:]CORRection:CSET[1][:SELect] <string>
To determine which sensor calibration table is currently selected, use the
following query:
[SENSe[1]:]CORRection:CSET[1][:SELect]?
Refer to
details.
Enabling sensor calibration tables
To enable a sensor calibration table, use the following command:
[SENSe[1]:]CORRection:CSET1:STATe ON
If you enable this command and no sensor calibration table has been selected,
error –221,"Settings conflict" occurs and this command remains disabled.
Refer to
details.
Keysight N432A Programming Guide
"[SENSe[1]:]CORRection:CSET[1][:SELect] <string>"
"[SENSe[1]:]CORRection:CSET[1]:STATe <boolean>"
N432A Remote Operation
on page 358 for
on page 362 for
1
89
Advertisement
Table of Contents
