12
SENSe Subsystem
SENSe Subsystem
The SENSe command subsystem directly affects device-specific settings used to
make measurements. The SENSe subsystem is optional since this is the primary
function of the N432A. The high-level command CONFigure uses the SENSe
commands to prepare the N432A for making measurements. At a lower level,
SENSe enables you to change the AVERage, BRESistance, RSELection, RVALue,
FREQuency, and CORRection parameters without completely reconfiguring the
N432A.
The SENSe command subsystem also allows you to select a sensor calibration
table and a frequency-dependent offset table.
The numeric suffix of the SENSe command (SENSe1) represents channel A.
Keyword
[SENSe[1]:]
AVERage
:COUNt
:VOLTage
:SDETect
BRESistance
RSEL
RVALue
CORRection
:CFACtor|GAIN[1]
[:INPut]
[:MAGNitude]
:CSET[1]
[:SELect]
:STATe
:CSET2
[:SELect]
:STATe
340
Parameter form
<character_data>
<boolean>
<character_data>
<character_data>
<numeric_value>
<numeric_value>
<string>
<boolean>
<string>
<boolean>
Note
Page
page 343
page 345
page 347
page 349
page 351
page 354
page 358
page 362
page 360
page 364
Keysight N432A Programming Guide