Keysight N432A Programming Manual page 455

–
Self-test Failed;
330
The –330,"Self-test Failed" errors indicate that you have a problem with your N432A. Refer to the N432A
Thermistor Power Meter User's Guide for details on how to manage your faulty N432A.
–
330 Self-test Failed;Measurement Channel Fault
–
330 Self-test Failed;Measurement Channel A Fault
– Self-test Failed;Calibrator Fault
330
Refer to the N432A Thermistor Power Meter User's Guide if you require a description of the calibrator test
–
330 Self-test Failed;ROM Check Failed
–
330 Self-test Failed;RAM Check Failed
– Queue overflow
350
The error queue is full and another error has occurred which could not be recorded
– Parity error in program
361
The serial port receiver has detected a parity error and consequently, data integrity cannot be guaranteed
– Framing error in program
362
The serial port receiver has detected a framing error and consequently, data integrity cannot be guaranteed
–
Input buffer overrun
363
The serial port receiver has been overrun and consequently, data has been lost
–
Query INTERRUPTED
410
A command which sends data to the output buffer was received, but the output buffer contained data from a
previous command (the previous data was not overwritten). The output buffer was cleared when power has
been turned off, or after a *RST (reset) command has been executed.
–
Query UNTERMINATED
420
The N432A was addressed to talk (that is, to send data over the interface) but a command which sends data
to the output buffer has not been received. For example, you may have executed a CONFigure command
(which does not generate data) and then attempted to read data from the remote interface.
–
Query DEADLOCKED
430
A command was received which generates too much data to fit in the output buffer and the input buffer is also
full. Command execution continues but data is lost.
Keysight N432A Programming Guide
SYSTem Subsystem 15
455