Table of Contents
Advertisement
–
Expression data not allowed
178
A legal expression data was encountered but not allowed by the N432A at this point
Example: FORM:BORD (5+2)
–
Trigger ignored
211
Indicates that <GET> or *TRG, or TRIG:IMM was received and recognized by the device but was ignored
because the N432A was not in the wait-for-trigger state
–
Init ignored
213
Indicates that a request for a measurement initiation was ignored as the N432A was already initiated
Example:
INIT:CONT ON
INIT
–
Trigger deadlock
214
TRIG:SOUR was set to HOLD or BUS and a READ? or MEASure? was attempted, expecting TRIG:SOUR
to be set to IMMediate
–
Parameter error; Frequency list must be in ascending order
220
Indicates that the frequencies entered using the MEMory:TABLe:FREQuency command are not in the
ascending order
–
Settings conflict
221
This message occurs under a variety of conflicting conditions. The following list gives a few examples of
where this error may occur:
– If the READ? parameters do not match the current settings
– Trying to clear a sensor calibration table when none is selected
–
Data out of range
222
A numeric parameter value is outside the valid range for the command
Example: SENS:FREQ 2 HZ
–
Illegal parameter value
224
A discrete parameter was received which was not a valid choice for the command. You may have used an
invalid parameter choice.
Example: TRIG:SOUR EXT
–
Lists not same length
226
This occurs when SENSe:CORRection:CSET[1]|CSET2:STATe is set to ON and the frequency and
calibration/offset lists do not correspond in length
Keysight N432A Programming Guide
SYSTem Subsystem
15
453
Advertisement
Table of Contents
