Parameters; Example - Keysight N432A Programming Manual

3 MEASurement Commands

Parameters

Refer to
parameters in this command.
Item
expected_value
(for the expected
power level)
resolution
source list
[a] The mnemonic DEF means DEFault. This is not equivalent to the DEFault parameter used in the command
[b] When the measurement result is linear, this parameter represents the number of significant digits. When the

Example

CONF3:DIFF DEF,1,(@1),(@1) This command configures the upper
158
"Optional parameters"
Description/Defaul t
The N432A ignores the numeric value entered for this
parameter. Any value entered is treated like DEF.
A numeric value for the resolution. If unspecified, the
current resolution setting is used.
Specifies the channels for calculating the difference
value. If unspecified and the current window setup is a
difference measurement, then this setup is used,
otherwise it defaults to A–A.
subsystems. The parameters must be entered in the specified order. If parameters are omitted, they default from
the right. The parameter DEFault is used as a placeholder. Specifying DEF leaves the parameter value unchanged.
measurement result is logarithmic, 1 to 4 represent 1, 0.1, 0.01, and 0.001 respectively.
on page 146 for additional details on the
window/lower measurement to perform a
difference measurement of
Channel A – Channel A with relative mode
off, using the current expected power level
and a resolution setting of 1.
Keysight N432A Programming Guide
Range of values
Sensor dependent
[a]
DEF
[b]
1 to 4
1.0, 0.1, 0.01, 0.001
[a]
DEF
(@1),(@1)