Table of Contents
Advertisement
1
N432A Remote Operation
Questionable Status register
The Questionable Status register set provides information on the quality of the
N432A measurement results. Any or all of these conditions can be reported in the
questionable data summary bit through the enable register. You must write a
value using the STATus:QUEStionable:ENABle command to set the enable
register mask.
The following bits in this register set are used by the N432A.
Table 1-5
Bit
0 to 2
3
4 to 7
8
9
10 to 15
Refer to
STATus:QUEStionable commands.
108
Bit definitions – Questionable Status register
Weight/Decimal
value
–
8
–
256
512
–
"Questionable Status Register Sets"
Definition
Not used
POWer summary
Not used
CALibration summary
Power-on self-test
Not used (bit 15 is always 0)
on page 423 for the
Keysight N432A Programming Guide
Advertisement
Table of Contents
