Keysight N432A Programming Manual page 226

4 CALCulate Subsystem
Reset condition
On reset, both windows and their measurements are set to ON.
Query
CALCulate[1]|2|3|4:LIMit:CLEar:AUTO?
This query enters a 1 or 0 into the output buffer indicating whether limit failures
are cleared automatically when a new measurement is initiated on the specified
window section.
– 1 is returned if limit failures are cleared automatically when a new
– 0 is returned if limit failures are not cleared automatically when a new
In the case where limit failures are cleared once, when a query occurs, a 1 is
entered into the output buffer if no measurement is initiated. If a measurement is
initiated, then 0 is entered.
Query example
CALC4:LIM:CLE:AUTO?
226
measurement is initiated.
measurement is initiated.
Queries whether the FCO is cleared for the lower
window/lower measurement.
Keysight N432A Programming Guide