Table of Contents
Advertisement
16
TRIGger Subsystem
TRIGger[1]:SOURce BUS|HOLD|IMMediate
This command configures the trigger system to respond to the specified source.
This command only selects the trigger source. Use the INITiate command to
place the N432A in the wait-for-trigger state.
This command has been included for compatibility purposes. It has the same
NOTE
purpose as TRIGger[:SEQuence[1]]:SOURce BUS|HOLD|IMMediate which should
be used in preference.
Syntax
Parameter
Item
source
486
TRIG
1
Description/Defaul t
Available trigger sources:
– BUS: The trigger source is the group execute trigger (GET) bus
command or the TRIGger:IMMediate SCPI command.
– HOLD: Triggering is suspended. The only way to trigger the N432A is to
use TRIGger:IMMediate.
– IMMediate: The trigger system is always true. If
INITiate:CONTinuous is set to ON, the N432A is continually
triggering free (free run mode). If an INITiate:IMMediate command
is sent, a measurement is triggered then the N432A returns to the idle
state.
Space
:SOUR
BUS
HOLD
IMM
?
Keysight N432A Programming Guide
Range of values
BUS
HOLD
IMMediate
Advertisement
Table of Contents
