Selecting the Segment Sweep as the Sweep Type
To execute a segment sweep by using the segment table you have
created, you must specify the sweep type for that sweep operation by
following the steps below.
1. Press
Sweep Setup
2. Press Sweep Type > Segment.
Setting the Horizontal Axis of the Graph (Frequency/Order Base Display)
Define the method of displaying traces when the segment sweep is
executed by following the steps described below.
1. Press
Sweep Setup
2. Press Segment Display > Freq Base|Order Base.
Calibration
Calibration
This chapter describes calibration methods for the E4990A Impedance
Analyzer.
Selecting Appropriate Calibration Method
•
A. Direct Connection Type Test Fixture
•
B. Calibration for Four-Terminal Pair, 1-m Extension
•
C. Calibration for Four-Terminal Pair, 2-m Extension
•
D. Exclusive Fixture
•
E. 42942A, 7-mm Port Extension
•
F. 42941A, Probe Adapter
•
G. 42941A, 3.5-mm Port Extension
•
User Calibration
•
Port Extension Compensation
•
Fixture Compensation
•
Selecting Calibration/Compensation Data Points
•
Selecting Appropriate Calibration Method
this is ON
display the sweep setup menu.
display the sweep setup menu.
Measurement
99