Keysight N432A Programming Manual page 369

[SENSe[1]:]CORRection:DCYCle|GAIN3:STATe <boolean>
This command is used to enable or disable the pulse power measurement feature.
The [SENSe[1]:]CORRection:DCYCle|GAIN3 command should be used to enter
the duty cycle of the signal you want to measure.
Syntax
SENS
1
Example
CORR:DCYC:STAT 1
Reset condition
On reset, the pulse power measurement feature is disabled.
Query
[SENSe[1]:]CORRection:DCYCle|GAIN3:STATe?
This query enters a 1 or 0 into the output buffer indicating the status of the pulse
power measurement feature.
– 1 is returned when enabled.
– 0 is returned when disabled.
Query example
CORR:GAIN3:STAT?
Keysight N432A Programming Guide
:
:DCYC
CORR
:GAIN3
:STAT
This command enables pulse power measurement.
Queries whether pulse power measurement is
enabled or disabled.
SENSe Subsystem
Space
0|OFF
1|ON
?
12
369