Keysight N432A Programming Manual page 64

1 N432A Remote Operation
Example 4 – Specifying the resolution parameter
The previous examples detailed the use of the expected power value and source
list parameters. The resolution parameter is used to set the resolution of the
specified window.
The following example uses the resolution parameter to specify a resolution
setting of 3. This setting represents three significant digits if the measurement unit
is W or %, and 0.01 dB if the unit is dB or dBm. Refer to
Commands
level and source list parameters are set to their default values in the example. The
expected power level remains unchanged at its current setting. As the source list
parameter is the last specified parameter, you do not have to specify DEF. The
measurement is carried out on the upper window.
Example 5 – Making a difference measurement
The following example queries the lower window to make a difference
measurement of Channel A – Channel A. The expected power level and resolution
parameters are defaulted, leaving them at their current settings.
64
for further details on the resolution parameter. The expected power
specifies window
MEAS1? DEF,3
specifies window
MEAS2:POW:AC:DIFF? DEF,DEF,(@1),(@1)
Chapter
specifies resolution setting
specifies the channels for
the difference measurement
Channel A – A
Keysight N432A Programming Guide
3, MEASurement