Keysight N432A Programming Manual page 248

Thermistor power meter

Hide thumbs Also See for N432A:

Table of Contents

CALibration Subsystem

CALibration commands are used to perform zeroing on the N432A as well as

apply the reference calibration factor for the thermistor sensor being used.

The numeric suffix of the CALibration command (CALibration1) represents

Zeroing of the N432A is recommended:

– when connection to the thermistor sensor is established.

– when you change the thermistor sensor.

– every 24 hours.

– prior to measuring low-level signals.

The CAL:ZERO:AUTO command is an overlapped command, where it allows the

N432A to continue parsing and executing subsequent commands while it is still

CALibration[1]

C change in temperature occurs.

Parameter form

<numeric_value>

<boolean>|ONCE

Keysight N432A Programming Guide