Table of Contents
Advertisement
16
TRIGger Subsystem
INITiate:CONTinuous:SEQuence[1] <boolean>
This command sets the N432A for either a single trigger cycle or continuous
trigger cycles. A trigger cycle means that the N432A exits the wait-for-trigger
state and starts a measurement.
If INITiate:CONTinuous:SEQuence[1] <boolean> is set to:
– OFF, the trigger system remains in the idle state until it is set to ON, or
– ON, the trigger system is initiated and exits the idle state. On completion of
– This command performs the same functions as INITiate[1]:CONTinuous
NOTE
– When entering local mode, INITiate:CONTinuous is set to ON.
Syntax
Example
INIT:CONT:SEQ ON
478
INITiate:IMMediate is received. Once this trigger cycle has completed, the
trigger system returns to the idle state.
each trigger cycle, the trigger system immediately commences another trigger
cycle without entering the idle state.
<boolean>.
INIT
:CONT
1
:SEQ
This command places the N432A in a wait-for-trigger
state.
Keysight N432A Programming Guide
Space
0|OFF
1|ON
?
Advertisement
Table of Contents
