Keysight N432A Programming Manual page 451

Error list
– Invalid character
101
An invalid character was found in the command string. You may have inserted a character such as #, $, or % in
the command header or within a parameter.
Example: LIM:LOW O#
– Syntax error
102
Invalid syntax was found in the command string
Example: LIM:CLE:AUTO, 1 or LIM:CLE: AUTO 1
–
Invalid separator
103
An invalid separator was found in the command string. You may have used a comma instead of a colon,
semicolon, or blank space; or you may have used a blank space instead of a comma.
Example: OUTP:ROSC,1
–
GET not allowed
105
A Group Execute Trigger (GET) is not allowed within a command string
–
Parameter not allowed
108
More parameters were received than expected for the command. You may have entered an extra parameter,
or added a parameter to a command that does not accept a parameter.
Example: CAL 10
–
Missing parameter
109
Fewer parameters were received than expected for the command. You may have omitted one or more
parameters that are required for this command.
Example: AVER:COUN:VOLT
– Program mnemonic too long
112
A command header was received which contained more than the maximum 12 characters allowed
Example: SENSeAVERageCOUNtVOLTage AVC8
– Undefined header
113
A command was received that is not valid for the N432A. You may have misspelled the command, it may not
be a valid command, or you may have selected the wrong interface. If you are using the short form of the
command, remember that it may contain up to four letters.
Example: TRIG:SOU IMM
– Invalid character in number
121
An invalid character was found in the number specified for a parameter value
Example: SENS:BRES R100#H
Keysight N432A Programming Guide
SYSTem Subsystem 15
451