Table of Contents
Advertisement
Parameters
Refer to
parameters in this command.
Item
expected_value
(for the expected
power level)
resolution
source list
[a] The mnemonic DEF means DEFault. This is not equivalent to the DEFault parameter used in the command
[b] When the measurement result is linear, this parameter represents the number of significant digits. When the
Example
FETC2?
Error messages
– If the last measurement is not valid, error –230,"Data corrupt or stale" occurs.
– If the expected power level and resolution parameters are not the same as the
Keysight N432A Programming Guide
"Optional parameters"
Description/Defaul t
This parameter can be set to DEF or a numeric value. If
a value is entered, it should correspond to that set by
CONFigure otherwise an error occurs. The units of
measurement are dBm and W. The default unit is
defined by UNIT:POWer.
A numeric value for the resolution. If unspecified, the
current resolution setting is used. If a value is entered, it
should correspond to the current resolution setting
otherwise an error occurs.
The channel which the command is implemented on. If
unspecified, the current window setup is used.
subsystems. The parameters must be entered in the specified order. If parameters are omitted, they default from
the right. The parameter DEFault is used as a placeholder. Specifying DEF leaves the parameter value unchanged.
measurement result is logarithmic, 1 to 4 represent 1, 0.1, 0.01, and 0.001 respectively.
Queries the lower window/upper measurement result.
A measurement is valid after it has been initiated. It becomes invalid when
either a reset occurs or any measurement parameter, for example frequency, is
changed.
current expected value and resolution setting on the specified window/
measurement, error –221,"Settings conflict" occurs.
MEASurement Commands
on page 146 for additional details on the
3
Range of values
Sensor dependent
[a]
DEF
[b]
1 to 4
1.0, 0.1, 0.01, 0.001
[a]
DEF
(@1)
167
Advertisement
Table of Contents
