MEMory[:METer][1]:TABLe Commands
These commands are used to define a sensor calibration table or a
frequency-dependent offset table, and to write to and read data from it.
The following commands are described in this section:
MEMory[:METer][1]:TABLe:FREQuency
<numeric_value>{,<numeric_value>}
MEMory[:METer][1]:TABLe:FREQuency:POINts?
MEMory[:METer][1]:TABLe:GAIN[:MAGNitude]
<numeric_value>{,<numeric_value>}
MEMory[:METer][1]:TABLe:GAIN[:MAGNitude]:POINts?
MEMory[:METer][1]:TABLe:MOVE <character_data>,<character_data>
MEMory[:METer][1]:TABLe:SELect <character_data>
Keysight N432A Programming Guide
MEMory Subsystem
10
315