Table of Contents
Advertisement
16
TRIGger Subsystem
– The trigger source is set to IMMediate on instrument power up and when
NOTE
– The MEASure and CONFigure commands automatically set the trigger source
– The READ? query or MEASure command should not be used if the trigger
Example
TRIG:SOUR IMM
Reset condition
On reset, the trigger source is set to IMMediate.
Query
TRIGger[:SEQuence[1]]:SOURce?
This query returns the current trigger source of either IMM, BUS, or HOLD.
Query example
TRIG:SOUR?
492
entering local mode.
to IMMediate.
source is set to BUS or HOLD.
Queries the current trigger source for the N432A.
This command configures the N432A for immediate
triggering.
Keysight N432A Programming Guide
Advertisement
Table of Contents
