Keysight N432A Programming Manual page 361

Thermistor power meter

Hide thumbs Also See for N432A:

Table of Contents

[SENSe[1]:]CORRection:CSET2[SELect]?

This query returns the name of the selected frequency-dependent offset table as a

quoted string. If no table is selected, an empty string is returned.

Query example

Error messages

– If the value entered for <string> is not valid, error –224,"Illegal parameter

– If a table with a name specified by <string> does not exist, error –256,"File

– When a sensor calibration table is selected, the N432A verifies that the

Keysight N432A Programming Guide

Queries the frequency-dependent offset table currently used.

value" occurs.

name not found" occurs.

number of calibration points defined is one more than the number of frequency

points defined. When a frequency-dependent offset table is selected, the

N432A verifies that the number of offset points defined is equal to the number

of frequency points defined. If this is not the case, error –226,"Lists not the

same length" occurs.

SENSe Subsystem