Table of Contents
Advertisement
1
N432A Remote Operation
MEASure? examples
The following examples demonstrate how to use the MEASure? query to make a
measurement. It is advisable to read through these examples in order, as they
become increasingly more detailed. These examples configure the N432A for a
measurement (as described in each individual example), automatically place the
N432A in the "wait-for-trigger" state, internally trigger the N432A to take one
reading, and then send the reading to the output buffer.
These examples give an overview of the MEASure? query. For further information,
refer to
Example 1 – The simplest method
The following example shows the simplest method of making single
measurements using MEAS?. Using MEAS1? results in an upper-window
measurement, and MEAS2? in a lower-window measurement. The channel can be
set using the source list parameter (refer to
parameter), or defaults as in this example.
62
"MEASurement Commands"
on page 145.
Example 2 – Specifying the source list
specifies window
MEAS1?
MEAS2?
Keysight N432A Programming Guide
Advertisement
Table of Contents
