Keysight N432A Programming Manual page 408

Thermistor power meter

Hide thumbs Also See for N432A:

Table of Contents

STATus Subsystem

Status Register Set Commands

This section describes the five status register set commands. Each can be used to

examine all of the eleven status registers listed on

To apply a command to a specific register, prefix the command with the name of

the appropriate register. For example, to apply the :ENABle command to the

STATus:QUEStionable register, use the following command:

STATus:QUEStionable:ENABle

The status register set commands detailed in this section are:

:NTRansition

:PTRansition

This query returns a 16-bit decimal-weighted number representing the bits set in

the Condition register of the SCPI register set you require to control. The return

format is <NR1> in the range of 0 to 32767 (2

Parameter form

[query only]

–1). The contents of the Condition

Keysight N432A Programming Guide